THREE Pretty Gold Flowered Cards
On tonight's Friday Night (Not So) Live video, I showed how to create these three elegant cards using Stampin' Up!'s outgoing Gold Foiled Flowers Cards & Envelopes. This product is on the Last Chance List, so grab them while you can!
A complete supply list for all three cards can be found at the bottom of this post, as well as a link to the replay of my Friday Night (Not So) Live.
CARD 1 Directions
- Stamp sentiment in Versamark ink onto Very Vanilla cardstock and heat emboss using Gold embossing powder. Die cut using the middle "rectangle" die from the Something Fancy dies.
- Determine where your sentiment layer will go on the card and add adhesive (I used Tear & Tape) to the area. Apply a zig-zag of Pretty Peacock & Gold Ribbon to the area.
- Adhere sentiment over ribbon using Dimensionals.
CARD 2 Directions
- Cut the Gold Flowers card down to get a panel that measures 3-3/4" x 5" (portrait).
- Using a Blending Brush, blend Pool Party ink into the top left corner, moving diagonally down the layer toward the center.
- Using a Blending Brush, blend Pretty Peacock ink from the bottom right corner toward the center.
- Adhere layer to the front of a Pretty Peacock card base (5-1/2" x 8-1/2", scored and folded in half at 4 -1/4").
- Using the same Blending Brush as you just used, blend Pretty Peacock ink onto the wing edges of a paper butterfly.
- Stamp sentiment on a scrap of Pool Party and die cut using the same die as you did in Card 1.
- Adhere sentiment layer to card front using Dimensionals.
- Adhere butterfly to card using basic adhesive where it attaches to the sentiment and a tiny piece of Dimensional to the largest area of the wings to give it a little support.
- Add three Pretty Peacock sequins.
- Decorate a 4" x 5-1/4" layer of Very Vanilla as desired (perhaps using a strip of the Gold Flowers that you have left over) and layer on the inside of the card.
CARD 3 Directions
- Trim the remaining piece of the Gold Foil Flowers card used on Card 2 to measure 2-1/2" x 5" (portrait).
- Color with Stampin' Blends. I used Sweet Sorbet, Fresh Freesia and Soft Sea Foam.
- Layer colored piece onto a layer of Gold Foil that measures 2-3/4" x 5-1/4", then adhere to the left side of a Sweet Sorbet card base (5-1/2" x 8-1/2", scored and folded in half at 4 -1/4").
- Stamp sentiment in Sweet Sorbet ink on a scrap of Very Vanilla cardstock and punch using the Decorative Circle punch. Adhere to card front using Dimensionals.
- Tie a small bow using the Gold Satin-Edged Ribbon and adhere to sentiment layer with a Mini Glue Dot.
- Color a flower from the scrap of Gold Foil Flowers card remaining using Sweet Sorbet Stampin' Blend, fussy cut and adhere to a Very Vanilla layer that measures 4" x 5-1/4". Adhere layer to inside of card.
Want to craft along with me as I create these cards?

























Comments
Post a Comment